Chamber furnace for heat treatment with fixed hearth СНО-3,5.5.3,5/11
№ | Specifications |
СНО-3,5.5.3,5/11
|
|||
---|---|---|---|---|---|
1 | Rated power, kW |
11 ±1
|
|||
2
|
Power supply | 3×380 V, 50 Hz | |||
3
|
Maximum temperature in the working space, ºС |
1100
|
|||
4 | Range of automatic temperature control, ºС | 50...1100 | |||
5 | Dimensions of working space, length × width × height, mm | 350 × 500 × 350 | |||
6 | Welded heat resistant steel pallet, 8 mm thick,with thermal compensation cuts and edges of rigidity | + | |||
7 | Atmosphere in the working space | Air | |||
8 | Stability of temperature control in the steady thermal conditions, without cages, ºС | ± 3 | |||
9 | Mechanism of opening the door | by hand | |||
10 | The heating element | Fechral, f 2.5 | |||
11 | Weight, kg | 800 | |||
12 | The height of the furnace feet, mm | 50 | |||
13 | Type of temperature regulator | ТРП-08-ТП (by default) |
Electric furnace chamber СНО-3,5.5.3,5/11 (industrial design) is equipped with an automatic temperature control system based on contactless solid-state relays and microprocessor temperature regulator TRP-08 TP, which allows you to set the temperature, the temperature set time and holding time at this temperature. The remote control for the operation of the furnace is located on the left side of the furnace. Heaters are placed in the grooves on the tubes side and end walls of the furnace and in the hearth. Hearth heaters are covered with ceramic tiles. The furnace lining with modern energy-saving materials, which provide a low loss of energy and quick access to the regime. Input and output ventilation holes with plugs provided in the oven to remove any gaseous products during heat treatment, and to speed up the cooling of cages. Welded pallet is made of heat-resistant steel 20H23N18 8.0 mm thick with a thermo-compensation cuts and ribs.
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: