Shaft-type furnace СШО-3.3.8/4,5 И1
№ | Specifications |
СШО-3.3.8/4,5 И1
|
|||
---|---|---|---|---|---|
Material of working chamber: И1 - black metal, coated heat-resistant paint | |||||
1 | Rated power, kW |
4 ±1
|
|||
2
|
Power supply | 220 W, 50 Hz | |||
3
|
Maximum temperature in the workspace, not more than, ºС |
450
|
|||
4 | Range of automatic temperature control, ºС | 40...450 | |||
5 | Dimensions of working space, length × width × height, mm | 300 × 300 × 800 | |||
6 | Overall dimensions, length × width × height, no more, mm Width specified without control panel of the furnace |
600 × 600 × 1200 | |||
7 | Stability of maintain the temperature at steady thermal conditions, without cages, not worse, ºС | ± 3 | |||
8 | Type of temperature regulator / Type of thermocouple | ТРП-08-ТП (by default)/ ТХК | |||
9 | Heaters | Heating elements | |||
10 | Atmosphere in the workspace | Air |
Electric furnace СШО-3.3.8/4.5 И1 is equipped with automatic temperature control system based on microprocessor controller and solid-state non-contact relay. The thermostat allows you to set the operating temperature, time to treatment and time spent on the operation. Heaters installed in the side walls of the chamber and the hearth. The control unit mounted on the left side of the kiln. The furnace lined with modern fiber insulating materials. The working chamber is made of black steel, covered with heat-resistant paint. Cover the oven is opened manually. On the cover of the furnace are fitting M20 × 1.5, length 20 mm, vertically fixed sensors. The design of seats and the number (≤50 ... 55) are consistent with the customer after the start of the Contract. Note: In this construction, the outer cover of the furnace temperature is raised relative to the side walls of the furnace.
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: