Chamber furnace СНО-9.12.6/10 for heat treatment
|1||Rated power, kW||
|Power supply||3×380 V, 50 Hz|
|Maximum temperature in the working space, ºС||
|4||Range of automatic temperature control, ºС||40...1000|
|5||Dimensions of working space, length × width × height, mm||900 × 1200 × 600|
|6||Material of spiral heaters||Х23Ю5Т|
|7||Atmosphere in the working space||Air|
|8||Stability of temperature control in the steady thermal conditions, without cages, ºС||± 3|
|9||Type temperature regulator / Type of thermocouple||ТРП-08-ТП (by default) / ТХА|
The electric furnace СНО-9.12.6/10 is designed for the heat treatment of different products in stationary conditions. The furnace is equipped with an automatic temperature control system: sets the temperature, heating speed to the predetermined temperature and holding time at this temperature. Temperature range from 40°С to 1000°С. Heaters are placed on the tubes in the slots of the side and end walls of the furnace, on the doors and in the hearth. Hearth heaters are covered with ceramic tiles. Hearth of the furnace lined with solid refractory materials, and chamber walls - by microporous and fibrous materials. Electric furnace has supply & exhaust air ventilation holes to remove any gas emissions. Also there are special channels in the side walls of the furnace for heat removal and forced air blowing on them. It provides the ability to control the temperature all over of oven chamber. The number of thermocouples - two, t a distance of 300 mm from the oven door and 300 mm from oven rear wall. Also available are holes for control thermocouples on the other hand on top of working thermocouples. The mechanism of opening and closing the oven door - electric drive.
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: